Shure DP11EQ User Manual download pdf (Page 24)

English –

SHURE LINK NETWORKS

Shure Link Connections

Up to 16 Shure Link devices can be linked together and controlled from a single computer. Each

unit comes supplied with one 5-pin DIN cable for linking.

DP11EQ #1 DP11EQ #2 DFR11EQ

COMPUTER

LINK OUTLINK IN LINK OUTLINK IN

LINK OUT LINK IN

1. Assign each unit a Device ID (0 through 15) via the DIP switches on the rear panel (see

Shure Link Device ID

, in the

Hardware

section of this manual).

NOTE: All units must have unique Device ID’s. The software will not allow

adjustments to be made to a Device ID which has multiple DP11EQ ’s assigned

to it.

2. Using the supplied 5-pin DIN cable, connect the Shure Link OUT of the first unit (the one

connected directly to the computer) to the Shure Link IN of the next unit. Repeat this

connection for each unit to be networked. The last unit in the chain should be

connected from its Shure Link OUT to the Shure Link IN of the first unit.

This

creates the loop necessary for all of the networked units to communicate with the

computer.

NOTE: Although a standard MIDI cable can be used to link units, Shure Link is

not MIDI compatible.

Shure Link Options

Shure Link Device Menu

The

Device

menu displays the following information:

 Device ID. This column lists all the Device ID’s

that are active in the network. The Device ID is

assigned through the DIP switches. See

Shure

Link Device ID

under

Introduction.

This column

also indicates when there are multiple units.

 Unit Name. See

Naming a DP11EQ .

 Scene. This column lists the name of the scene

that is active in the device and the status of that

scene if it has been modified. Once a modified

scene has been saved to disk, the modified status

changes.

 Configuration. This column lists the signal

processing modules active in that scene. The

modules are listed in abbreviations as follows:

DP = Dynamics Processor

PEQ = Parametric Equalizer

GEQ = Graphic Equalizer

DLY = Delay

3.X = DFR11EQ Version 3.X

MEM ERR = Corrupted unit

NOTE: To access multiple units, please make sure that each unit has been

assigned a different Device ID. If two or more units share the same Device ID,

those units will be inaccessible to computer control. Make sure that each device

in a Shure Link network has a different Device ID.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 35 36

Comments to this Manuals

No comments

Shure DP11EQ User Manual Page 24

Comments to this Manuals

Related products and manuals for Musical Equipment Shure DP11EQ