Shure LX4 User's Guide download pdf (Page 15)

English

FIGURE 14

LX1 BODY-PACK SYSTEM SETUP AND OPERATION

OPERATING LX1 BODY-PACK SYSTEMS

1. Clip the LX1 body pack transmitter to your belt, waistband, or guitar strap.

2. Connect the lavalier microphone, headset or instrument adapter cable to the body-

pack transmitter.

3. If you are using a lavalier microphone, clip the mic to your tie, lapel, or other gar-

ment. If you are using a headset, put the headset on. If you are using a Shure

WM98 microphone, insert it into an A98KCS horn mount and clamp it to your horn.

If you are using an instrument adapter cable, plug the cable into the instrument.

4. Slide the transmitter PWR/OFF switch to the PWR position. One of the three lights

on the transmitter illuminates.

5. Press the POWER button on the receiver. The green “power on” light on the

receiver and the RF light(s) illuminates.

6. Slide the transmitter ON/MUTE switch to the ON position and begin speaking or

playing your instrument.

NOTE: If the red PEAK light on the receiver does not flicker during the loudest

sounds, the transmitter gain may need to be increased. Refer to the Adjusting the

Transmitter Audio Gain Level section. Then, if the system is still not operating

properly, consult the Troubleshooting table.

7. During the performance or presentation, slide the ON/MUTE switch to the MUTE

position when the system is not in use.

8. When the performance or presentation is over, slide the transmitter PWR/OFF

switch to the OFF position to conserve battery power.

WH20

HEADSET

WM98 MIC AND

AK98KCS MOUNT

WA302 INSTRUMENT

ADAPTER CABLE

LAVALIER

MICROPHONE

RECEIVER

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 25 26

No comments

Shure LX4 User's Guide Page 15