Shure AMS28 User's Guide download pdf (Page 11)

English --

SETUP

MOUNTING

To mount the AMS8100 in a rack-mount in a standard

19-inch audio equipment rack, install the mixer using the sup-

plied Phillips head screws through each side panel. Use all

four screws.

CONNECTIONS

Make audio c onnections as follows:

AUDIO CONNECTIONS

TO STEREO OR MONO HEADPHONES

FROM AUX-- OR LINE--LEVEL SOURCE

TO AMP/RECORD/MIXER INPUT

OR FROM AUX SOURCE (CH. 8)

TO LINKED AMS8100 MIXERS

TO ADVANCED FUNCTION WIRING

TO AC POWER SOURCE

TO AMP/REC/MIXER INPUT (CH. 1--7)

FROM AMS MICS (CH. 1--8)

MIXER OUTPUT TO AMP/REC/MIXER INPUT

1. Connect an AMS microphone to the Channel Input con -

nectors (use high -quality 2-conductor shielded cables). It

is important to connect the red wire from the AMS micro-

phone cable to the first pin of the block connector, the

black wire to the second pin of the block connector, and

the shield to the last pin of the block c onnector.

2. Connect the AMS8100 Line Level Output to the input of

mixers, EQs, amplifiers or recorders.

3. If additional AMS8100 mixers are to be linked to increase

the number of microphone inputs, connect them by

means of the Link In and Link Out jacks. Connect the LINK

OUT of the first mixer to the LINK IN of the next mixer, and

so on. Leave the LINK IN jack of the first mixer and the

LINK OUT jack of the last mixer unconnected. NOTE:

These jacks are for linking only, not for audio inputs or out -

puts (see Figure 5).

LINKING MIXERS

4. For headphone monitoring, connect headphones to the

front-panel

-inch PHONES jack.

5. Connect the power cord to the appropriate power source.

If the operating voltage is to be changed, refer to the Volt-

age Selection section.

CONTROL SETTINGS

1. Turn on the Power switch.

2. Adjust each channel level so that its Overload LED flick-

ers only during very loud speech.

3. Adjust the Low-Cut and High-Frequency controls adja -

cent to each Input Gain control to make each microphone

sound similar.

4. Adjust the AMS8100 Master level control for the required

output level, as indicated by the output peak meter.

5. Adjust the headphone volume level with the PHONES

control knob.

6. The AMS8100 is now ready for operation.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Comments to this Manuals

No comments

Shure AMS28 User's Guide Page 11

Comments to this Manuals

Related products and manuals for Microphones Shure AMS28